memory.c

Go to the documentation of this file.

/* SPDX-License-Identifier: GPL-2.0-or-later */
 
#include <baseboard/gpio.h>
#include <baseboard/variants.h>
#include <gpio.h>
 
static const struct mb_cfg baseboard_memcfg = {
        .type = MEM_TYPE_LP4X,
 
        .rcomp = {
                /* Baseboard uses only 100ohm Rcomp resistors */
                .resistor = 100,
 
                /* Baseboard Rcomp target values */
                .targets = {40, 30, 30, 30, 30},
        },
 
        /* DQ byte map */
        .lpx_dq_map = {
                .ddr0 = {
                        .dq0 = {  9, 11,  8, 10, 12, 14, 13, 15, },
                        .dq1 = {  4,  7,  6,  5,  2,  3,  0,  1, },
                },
                .ddr1 = {
                        .dq0 = { 15, 12, 14, 13,  9, 10, 11,  8, },
                        .dq1 = {  0,  1,  3,  2,  7,  5,  4,  6, },
                },
                .ddr2 = {
                        .dq0 = {  2,  3,  1,  0,  6,  7,  5,  4, },
                        .dq1 = { 15,  9, 14,  8, 11, 10, 13, 12, },
                },
                .ddr3 = {
                        .dq0 = {  3,  1,  2,  0,  4,  6,  7,  5, },
                        .dq1 = { 13, 15, 14, 12, 11,  9,  8, 10, },
                },
                .ddr4 = {
                        .dq0 = { 13, 12, 14, 15,  9,  8, 10, 11, },
                        .dq1 = {  4,  7,  5,  6,  1,  2,  0,  3, },
                },
                .ddr5 = {
                        .dq0 = {  5,  0,  6,  4,  3,  1,  7,  2, },
                        .dq1 = { 11,  9, 10,  8, 15, 12, 14, 13, },
                },
                .ddr6 = {
                        .dq0 = { 15, 12, 14, 13, 10,  9, 11,  8, },
                        .dq1 = {  0,  1,  2,  3,  5,  6,  4,  7, },
                },
                .ddr7 = {
                        .dq0 = {  0,  3,  1,  2,  4,  5,  6,  7, },
                        .dq1 = { 11,  8, 13, 14,  9, 12, 15, 10, },
                },
        },
 
        /* DQS CPU<>DRAM map */
        .lpx_dqs_map = {
                .ddr0 = { .dqs0 = 1, .dqs1 = 0 },
                .ddr1 = { .dqs0 = 1, .dqs1 = 0 },
                .ddr2 = { .dqs0 = 0, .dqs1 = 1 },
                .ddr3 = { .dqs0 = 0, .dqs1 = 1 },
                .ddr4 = { .dqs0 = 1, .dqs1 = 0 },
                .ddr5 = { .dqs0 = 0, .dqs1 = 1 },
                .ddr6 = { .dqs0 = 1, .dqs1 = 0 },
                .ddr7 = { .dqs0 = 0, .dqs1 = 1 },
        },
 
        .ect = 1, /* Enable Early Command Training */
};
 
const struct mb_cfg *__weak variant_memory_params(void)
{
        return &baseboard_memcfg;
}
 
int __weak variant_memory_sku(void)
{
        /*
         * Memory configuration board straps
         * GPIO_MEM_CONFIG_0    GPP_E11
         * GPIO_MEM_CONFIG_1    GPP_E2
         * GPIO_MEM_CONFIG_2    GPP_E1
         * GPIO_MEM_CONFIG_3    GPP_E12
         */
        gpio_t spd_gpios[] = {
                GPP_E11,
                GPP_E2,
                GPP_E1,
                GPP_E12,
        };
 
        return gpio_base2_value(spd_gpios, ARRAY_SIZE(spd_gpios));
}
 
bool __weak variant_is_half_populated(void)
{
        /* GPIO_MEM_CH_SEL GPP_E13 */
        return gpio_get(GPP_E13);
}
 
void __weak variant_get_spd_info(struct mem_spd *spd_info)
{
        spd_info->topo = MEM_TOPO_MEMORY_DOWN;
        spd_info->cbfs_index = variant_memory_sku();
}