bootblock.c

Go to the documentation of this file.

/* SPDX-License-Identifier: GPL-2.0-only */
 
#include <device/mmio.h>
#include <bootblock_common.h>
#include <device/i2c_simple.h>
#include <soc/addressmap.h>
#include <soc/clk_rst.h>
#include <soc/clock.h>
#include <soc/funitcfg.h>
#include <soc/nvidia/tegra/i2c.h>
#include <soc/padconfig.h>
#include <soc/spi.h>    /* FIXME: move back to soc code? */
 
#include "pmic.h"
 
static const struct pad_config pmic_pads[] = {
        PAD_CFG_SFIO(PWR_I2C_SCL, PINMUX_INPUT_ENABLE, I2CPMU),
        PAD_CFG_SFIO(PWR_I2C_SDA, PINMUX_INPUT_ENABLE, I2CPMU),
};
 
static const struct pad_config spiflash_pads[] = {
        /* QSPI fLash: mosi, miso, clk, cs0, hold, wp  */
        PAD_CFG_SFIO(QSPI_IO0, PINMUX_INPUT_ENABLE | PINMUX_PULL_UP, QSPI),
        PAD_CFG_SFIO(QSPI_IO1, PINMUX_INPUT_ENABLE | PINMUX_PULL_UP, QSPI),
        PAD_CFG_SFIO(QSPI_SCK, PINMUX_INPUT_ENABLE, QSPI),
        PAD_CFG_SFIO(QSPI_CS_N, PINMUX_INPUT_ENABLE, QSPI),
        PAD_CFG_SFIO(QSPI_IO2, PINMUX_INPUT_ENABLE | PINMUX_PULL_UP, QSPI),
        PAD_CFG_SFIO(QSPI_IO3, PINMUX_INPUT_ENABLE | PINMUX_PULL_UP, QSPI),
};
 
/********************* TPM ************************************/
static const struct pad_config tpm_pads[] = {
        PAD_CFG_SFIO(GEN3_I2C_SCL, PINMUX_INPUT_ENABLE, I2C3),
        PAD_CFG_SFIO(GEN3_I2C_SDA, PINMUX_INPUT_ENABLE, I2C3),
};
 
static const struct funit_cfg funits[] = {
        /* PMIC on I2C5 (PWR_I2C* pads) at 400kHz. */
        FUNIT_CFG(I2C5, PLLP, 400, pmic_pads, ARRAY_SIZE(pmic_pads)),
        /* SPI flash at 24MHz on QSPI controller. */
        FUNIT_CFG(QSPI, PLLP, 24000, spiflash_pads, ARRAY_SIZE(spiflash_pads)),
        /* Foster has no TPM yet. This is for futurn TPM on I2C3  @ 400kHz. */
        FUNIT_CFG(I2C3, PLLP, 400, tpm_pads, ARRAY_SIZE(tpm_pads)),
};
 
static const struct pad_config uart_console_pads[] = {
        /* UARTA: tx, rx, rts, cts */
        PAD_CFG_SFIO(UART1_TX, PINMUX_PULL_NONE, UARTA),
        PAD_CFG_SFIO(UART1_RX, PINMUX_INPUT_ENABLE | PINMUX_PULL_UP, UARTA),
        PAD_CFG_SFIO(UART1_RTS, PINMUX_PULL_UP, UARTA),
        PAD_CFG_SFIO(UART1_CTS, PINMUX_PULL_UP, UARTA),
};
 
void bootblock_mainboard_early_init(void)
{
        soc_configure_pads(uart_console_pads, ARRAY_SIZE(uart_console_pads));
}
 
static void set_clock_sources(void)
{
        /* UARTA gets PLLP, deactivate CLK_UART_DIV_OVERRIDE */
        write32(CLK_RST_REG(clk_src_uarta), PLLP << CLK_SOURCE_SHIFT);
}
 
void bootblock_mainboard_init(void)
{
        set_clock_sources();
 
        soc_configure_funits(funits, ARRAY_SIZE(funits));
 
        i2c_init(I2CPWR_BUS);
        pmic_init(I2CPWR_BUS);
 
        /* Foster has no TPM yet. This is for future TPM. */
        i2c_init(I2C3_BUS);
}